View Single Post
Old 02-27-2020, 06:27 PM
itsid's Avatar
itsid itsid is offline
Join Date: Jul 2013
Location: Ruhrpott [Germany]
Posts: 11,049
Thanks: 1,483
Thanked 4,594 Times in 3,467 Posts

Sorry, morpheus caught me on the couch

Yepp that's all correct..
I'm still unsure if that tantal cap has enough room inside the motor case.
But since we don't need to power the motor just turn the shaft by hand I hope it'll be fine.

Now, insert the HE sensor to the sensor xcasing inside the motor housing,
solder it to the original sensor wires
bend the cap out of the way so you can reinstall the motor end cap
(we need the rotor to be in two bearings to not hit the stator)

And then... there'll be nothing left but to connect the arduino to the USB power of yopur computer and follow the instructions of the serial monitor.

I'll have my fingers crossed.

Jokes about german sausage are the wurst.
Reply With Quote