Go Back   DIY Go Kart Forum > Search Forums

Notices

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: theo
Forum: FAQ & Articles 03-20-2012, 08:59 AM
Replies: 99
Views: 77,649
Posted By theo
Here is a drawing of a bell crank to go with...

Here is a drawing of a bell crank to go with AZUSA spindles.


http://i24.photobucket.com/albums/c14/theo44/PitmanArm1-2.jpg

I don't know the measurement off the AZUSA spindles, someone else...
Forum: FAQ & Articles 01-20-2012, 10:16 PM
Replies: 99
Views: 77,649
Posted By theo
I put the ackerman into the bell crank because I...

I put the ackerman into the bell crank because I was using AZUSA spindles.
This is what I did to figure out how to make the bell crank:
Draw a line from the spindle to the center of the axle...
Forum: FAQ & Articles 01-20-2012, 03:11 PM
Replies: 99
Views: 77,649
Posted By theo
You can achieve ackerman at the spindles and at...

You can achieve ackerman at the spindles and at the bellcrank. Now if you do both then the inner tire has to much angle and the outer one has not enough. If you look at my steering i have my ackerman...
Forum: FAQ & Articles 01-20-2012, 12:45 PM
Replies: 99
Views: 77,649
Posted By theo
You should attach the tie rods to the bell crank...

You should attach the tie rods to the bell crank with one center hole. The way you are set up now you have ackerman at the spindles and you are adding more at the steering shaft bell crank. The stops...
Forum: FAQ & Articles 01-20-2012, 08:50 AM
Replies: 99
Views: 77,649
Posted By theo
you might have to much ackerman in you inside...

you might have to much ackerman in you inside wheel.
Forum: FAQ & Articles 01-19-2012, 05:04 PM
Replies: 99
Views: 77,649
Posted By theo
You could cut the spindles off and swap them from...

You could cut the spindles off and swap them from side to side, add 10 - 12 deg. of caster. Shorten the bell crank and change it from pointing up to pointing down. This will cure a lot of your...
Showing results 1 to 6 of 6

 

All times are GMT -6. The time now is 01:46 AM.