Go Back   DIY Go Kart Forum > Search Forums

Notices

Showing results 1 to 9 of 9
Search took 0.00 seconds.
Search: Posts Made By: OzFab
Forum: FAQ & Articles 10-05-2014, 07:20 PM
Replies: 99
Views: 77,960
Posted By OzFab
For those who are not sure what you're referring...

For those who are not sure what you're referring to, can you add a little more detail about offset control arms?

On your monster, I would say you definitely need caster...
Forum: FAQ & Articles 02-16-2014, 08:52 PM
Replies: 99
Views: 77,960
Posted By OzFab
Technically, that is correct. Steering...

Technically, that is correct. Steering measurements are taken from a perpendicular or vertical plane, not a horizontal plane so, 90 from the horizontal plane becomes 0 & +5 would be -85 from the...
Forum: FAQ & Articles 09-12-2013, 02:51 AM
Replies: 99
Views: 77,960
Posted By OzFab
I heard somewhere that McCullough go karts have...

I heard somewhere that McCullough go karts have a 14 crossover angle. Now, converting that to measurements is the difficult part because the distance between the two holes will depend on how far...
Forum: FAQ & Articles 02-19-2013, 05:31 PM
Replies: 99
Views: 77,960
Posted By OzFab
First up, your best option is to move your post...

First up, your best option is to move your post to a new thread, it'll get more positive attention
Forum: FAQ & Articles 09-30-2012, 10:06 PM
Replies: 99
Views: 77,960
Posted By OzFab
You can achieve ackermann with forward facing...

You can achieve ackermann with forward facing arms, but you may run into clearance issues between the end of the arm & the wheel. Double check before you start!

It's much easier with rear facing...
Forum: FAQ & Articles 07-16-2012, 06:58 PM
Replies: 99
Views: 77,960
Posted By OzFab
So, how did you do that?

So, how did you do that?
Forum: FAQ & Articles 07-02-2012, 10:31 AM
Replies: 99
Views: 77,960
Posted By OzFab
After explaining Ackermann to a member I thought...

After explaining Ackermann to a member I thought "there should be a thread here somewhere that includes all this" & I was about to create one. So I did a more thorough search & there it is!
Forum: FAQ & Articles 07-02-2012, 09:38 AM
Replies: 99
Views: 77,960
Posted By OzFab
Good one! Thanks :thumbsup:

Good one! Thanks :thumbsup:
Forum: FAQ & Articles 07-01-2012, 10:38 AM
Replies: 99
Views: 77,960
Posted By OzFab
Since there are a lot of posts asking for the...

Since there are a lot of posts asking for the type of info in this thread & this thread provides said info, why is it not a sticky?
Showing results 1 to 9 of 9

 

All times are GMT -6. The time now is 05:19 AM.