Go Back   DIY Go Kart Forum > Search Forums

Notices

Showing results 1 to 4 of 4
Search took 0.01 seconds.
Search: Posts Made By: Kartorbust
Forum: Off Topic Forum 11-10-2018, 01:36 PM
Replies: 17
Views: 1,111
Posted By Kartorbust
If you did do aluminum with it, you may look at...

If you did do aluminum with it, you may look at doing it with a push/pull gun. Feeds a lot nicer than a spool gun and doesn't usually jam up. Though I'm not sure if Miller makes one for the 252.
Forum: Off Topic Forum 11-09-2018, 07:23 AM
Replies: 17
Views: 1,111
Posted By Kartorbust
It will cost a small fortune to get this up and...

It will cost a small fortune to get this up and running again, but it could be worth it. https://www.millerwelds.com/support/manuals-and-parts
Forum: Off Topic Forum 11-06-2018, 09:26 PM
Replies: 17
Views: 1,111
Posted By Kartorbust
A few pictures of the machine and even pop open...

A few pictures of the machine and even pop open the access panel maybe we can pin point the model.
Forum: Off Topic Forum 11-06-2018, 09:21 PM
Replies: 17
Views: 1,111
Posted By Kartorbust
So roughly the size of the Hobart Ironman 230v....

So roughly the size of the Hobart Ironman 230v. Drive motors can go out, as well as the drive rollers can wear out. Anything on the electrical side that powers the machine, probably capacitors go out...
Showing results 1 to 4 of 4

 

All times are GMT -6. The time now is 03:39 AM.