PDA

View Full Version : Baja Dune 150

Nishnabe
04-06-2009, 11:32 AM
Alright so I picked this baby up Sunday for 500 dollars and then I get a call from this dude I have been trying to get ahold of for like 5 weeks. He is selling a 2005 Roketa 250 atv for 250 bucks because it has a broken axle.

Well how hard will it be to put that drive train into my kart?
Nishnabe
04-06-2009, 05:07 PM
How do you take this off
http://c2.ac-images.myspacecdn.com/images02/107/l_6999378fe69b410a9f202e191c1c8019.jpg
Kaptain Krunch
04-06-2009, 05:12 PM
a strap wrench would work well, then you most likely need a wheel puller to get the actual flywheel off, or you can be cheap like me and use a few flathead screwdrivers and apply even pressure on both sides (carefully.
thgrahamjr
04-06-2009, 07:19 PM
That's a GY6 Honda clone, I have one also and had to remove the flywheel to replace the stator. I put two bolts in the flywheel where the fan bolts up and used a big screw driver put through the two bolts to hold it while I removed the end nut.
Nishnabe
04-06-2009, 09:13 PM
thanks i just seen it on youtube :thumbsup:
Kenny_McCormic
04-07-2009, 06:33 PM
Impact gun and harmonic balancer puller to remove, strap wrench and torque wrench to reinstall.
Nishnabe
04-07-2009, 07:03 PM
I tried the bolts thing it didnt work. I currently dont have access to impact gun
Nishnabe
04-07-2009, 07:07 PM
is this nut lefty loosey righty tighty?
thgrahamjr
04-07-2009, 07:37 PM
I can't remember but try it both ways.
Nishnabe
04-07-2009, 09:05 PM
well i went out and bought a compressor and air tools so tommorrow I shall try the impact wrench:smartass:
ed1380
04-07-2009, 10:56 PM
http://www.rc-trucks.org/gy6-engine-performance.htm
Nishnabe
04-08-2009, 08:27 PM
So I took the impact wrench to it and brrrzzz brrrrzzz it came off like it was nothing. I cant believe it was that easy.

Anyways I installed the new coil and CDi no spark tomorrow my stator shoudl come in.

If that doesnt work I guess I will be tracing every single wire.
Kaptain Krunch
04-09-2009, 04:49 PM
You should always trace every wire first, then test each component with a multi-meter. It saves money, and time waiting for parts to come in the mail
Nishnabe
04-09-2009, 07:37 PM
Your absolutely right. It turns out that the AC Power wire and trigger pulse wire were crossed. :out:

But I have an upgraded ignition and as soon as I get my uni, jets and yellow spring I will be modded real good. So actually I am not losing any money. per say.

THanks for the help guys.
motor_head
05-31-2009, 01:19 PM
He is selling a 2005 Roketa 250 atv for 250 bucks because it has a broken axle.

Well how hard will it be to put that drive train into my kart?

buy it
shouldn't be to hard