13hp Honda clone with comet 40 series.....

[5trucks]

clutch,driver and driven. I am getting rid of this only because my boy wants an engine with more balls. This is a great set-up and works really well moving my boys kart around. Belt is in almost new condition as is the clutch. The engine has no fuel tank or governor because i use a 6gal gravity feed vw tank instead. Pics are of engine as it sits now. Always garaged and runs great. Pull and electric start. Would like $200.00 plus whatever shipping is for the set up.

[Techman-10]

Where is this little ride at?:confused: :huh:

[5trucks]

Sorry about that. I'm in Texas. 78664

[Justin]

Sorry about that. I'm in Texas. 78664

if only you was closer -.-

[oscaryu1]

Too close 4 me xD

More balls? Those GX390's have plenty of mods to them. If not enough $$$, throw a GX200 and mod it on there.

I'll tell ya though, that thing must have TORQUE. GX390 + Comet 40 = Holy moliez.

[ed1380]

$200? am i reading this right?

[Nishnabe]

Find out what shipping is to 74801.:thumbsup:

[KingCobra]

I have the GX 390 13 hp Honda with the 1" shaft and all I find is "8 hp or less Comet clutches" or any clutches for that matter. I need one for a #41 chain. Does that clutch rate for 13 hp? Or need I pay no attention to the ratings? You buggy is well worth more that your asking price! Good luck. Wished I lived near ya :DThanx. scott

[oscaryu1]

I have the GX 390 13 hp Honda with the 1" shaft and all I find is "8 hp or less Comet clutches" or any clutches for that matter. I need one for a #41 chain. Does that clutch rate for 13 hp? Or need I pay no attention to the ratings? You buggy is well worth more that your asking price! Good luck. Wished I lived near ya :DThanx. scott

I run a $30 clutch on my Clone. Just don't go throttle all the time and go riding up 45 degree cliffs and you should be fine. Could gear lower to lower the stress on the clutch :)

[KingCobra]

cool.Thankx

[newrider3]

The kart in the OP's pics has a Comet 40 series torque convertor, good for 18 horsepower.