Go kart pics

[mikeandike]

i got the pics... i had some trouble with the motor mounting and the bearings. The motor alignment was all out of whack so i redrilled them and the bearings had to be moved back to tighten the chain so i redrilled that too then my dad realised that we could have put shims in between the bearings and the frame to tighten it...

[mikeandike]

More pics...

[mikeandike]

Even more pics...

I had to lower the quality of some of the pics so they would uplaod

[Lead Foot]

looks great man! Keep us updated.

[robertdjung]

ncie work! for the engine mounting, there's no plate -- is that coming later, or did you drill through the frame?

[mikeandike]

i drilled through the frame... my frame is aluminum so it was pretty forgiving for the screwed up engine mounting holes

I used nylocks on all the bolt i put in so they wont vibrate out. For those of you who dont know what nylocks are theyre a nut with a small nylon ring at the end theyre very annoying if u have to thread them on a long bolt sticking out but THEY WONT COME LOOSE WITHOUT A WRENCH :)

[robertdjung]

just worried since you won't have any way to adjust the tension of the chain...

[Lead Foot]

Thats what shims are for,lol

[mikeandike]

ya if the chain get looser add a bigger shim in

[robertdjung]

I'd never thought of it that way. Vaya!

[mat1]

did you get your stuff from princess auto??? ant is that a 7/8'' axel

[mikeandike]

most of it yes. But no thats a 1" axle and i got it for free

[mikeandike]

will aluminun C brackets for the spindles be strong enough to hold up a go kart? because i'm either going to weld an aluminum front on or make a steel front that slides into the existing frame and bolt it on

[mat1]

most of it yes. But no thats a 1" axle and i got it for free

me to mine 1inch and same set up as u it works good